Remove the existing Key and, within five seconds, insert a second Key and turn it to ONĤ. Insert an existing Key into the ignition cylinder.ģ. After the first two Keys are programmed, additional Keys can be entered individuallyīy following the instructions for adding duplicate Keys.Īdd Duplicate Key (Requires two working Keys)ġ. Two new Keys should be ready because the system requires a minimum of two Keys in the This requires that the vehicle be connected to special diagnostic equipment (TKO/SDD). Key codes and is the ONLY key programmed into the vehicle’s computer.ġ. It has replaced ALL the previous electronic The vehicles computer and will operate the car. After the security light stops flashing the third time, the new key has been programmed into The ignition cylinder to OFF and then back to the ON (RUN) position. When the security light stops flashing, you have five minutes to start the next step. The dash will flash for fifteen more minutes.ģ. The ignition cylinder OFF and then back to the ON (RUN) position. On the dash will flash for fifteen minutes.Ģ. If the vehicle doesn’t have a security light, leave the key in for 10 minutes and 30 seconds during The security light will go off once the key has been programmed. Insert key to be programmed and turn to ON within 15 seconds of removing the alreadyĤ. Insert already programmed key into ignition and START car.ģ. If the Add Duplicate key instructions above did not work follow the variation below.ġ. The security light will light up for two seconds to indicate success in programming the key Remove the existing key and, within fifteen seconds, insert the new key and turn it to ONĤ.
Turn the ignition cylinder to ON (RUN) and back to OFF.ģ. Insert an existing key into the ignition cylinder.Ģ. It has replaced ALL the previous electronic keyĬodes and is the ONLY key programmed into the vehicle’s computer.ġ. Vehicle’s computer and will operate the car. After the security light has gone off the third time, the key has been programmed into the Will illuminate and stay on for ten more minutes.Ĥ. Turn the ignitionĬylinder to OFF and then back on the ON (RUN) position. When the security light goes out, you have one minute to start the next step. Illuminate and stay on for ten more minutes.ģ. Turn the ignitionĬylinder to OFF and then back to the ON (RUN) position. On the dash will illuminate and stay on for ten minutes.Ģ.
Insert new key into ignition cylinder and turn it to the ON (RUN) position.
Here are a list of vehicle models and their programming procedures:Ģ010-2012 Ford Edge/Explorer/Taurus & Lincoln MKS/MKTġ. The most common manufacturers with on board programming are GM, Ford, Chrysler, Mazda, Toyota and Lexus. Note most of the time you need a current working key. A on board programming procedure is a serious of actions with the vehicle that put it into learn mode to accept the addition of another key. On some vehicles with transponder chips there are on board programming procedures available. Home > Services > Automotive > On Board Programming